Lyman Mag Inertia Bullet Puller 7810216 - Magnum Orange/Black

The Lyman Mag Inertia Bullet Puller is the reloader's go-to tool for safely pulling bullets from loaded rounds without damaging brass or projectiles. Whether you've loaded a batch with the wrong powder charge, grabbed the wrong bullet by mistake, or need to salvage components from old ammo, this tool gets the job done in seconds—no press required. Just place the round in the puller, strike the tool head against a solid surface, and inertia does the work for you.

Built with a redesigned head that handles everything from standard cartridges up to large magnum cases, this inertia puller covers the full spectrum of rifle and handgun reloading. The ergonomic handle gives you a secure, comfortable grip during repeated use, which matters when you're pulling dozens of rounds. The magnum orange and black finish is easy to spot on the bench, and the simple, durable construction means it'll outlast trends in your reloading room.

If you're serious about ammunition reloading—whether you're sorting through mixed lots, correcting loading mistakes, or managing component inventory—an inertia bullet puller belongs in your kit. It's faster than a press-mounted puller for one-off jobs and requires no setup beyond a solid work surface.

Key Features

• Inertia-driven design pulls bullets safely without a reloading press
• Redesigned head accommodates standard through large magnum cartridge cases
• Separates bullet from brass without damage to either component
• Ergonomic handle for comfortable, secure grip during extended use
• Quick operation—no setup or adjustment needed

Frequently Asked Questions

What calibers does the Lyman Mag Inertia Bullet Puller work with?

The redesigned head is engineered to handle a wide range of calibers, from standard rifle and handgun rounds up to large magnum cases. If you're reloading anything from .223 to .338 Lapua or similar magnum sizes, this puller will accommodate it.

Do I need a reloading press to use this bullet puller?

No. The inertia puller works independently—you simply insert the loaded round and strike the tool head against a solid work surface. A reloading bench or concrete surface works fine.

Will it damage my bullets or brass cases?

The tool is designed to separate bullets from cartridge cases safely without harming either component, allowing you to reuse both the brass and the bullet.