Mec 1311095 Bullet Puller

The Mec-Gar USA Mec 1311095 bullet puller is a straightforward, reusable tool for disassembling loaded cartridges—an essential piece of reloading equipment when you need to salvage components from a round that didn't work out. Whether you're correcting a seating mistake, pulling bullets from old ammo, or recovering brass and projectiles from a failed load, this hand-operated puller gets the job done without fuss. Made in the USA, it's built to handle repeated use in your reloading workspace.

Operation is simple: insert your cartridge with the corresponding cap piece that matches your cartridge size, then strike the puller firmly against a hard, flat surface. The impact dislodges the bullet from the case, letting you recover the projectile, brass, and powder for reuse. It's a low-cost, mechanical solution that requires no power and won't jam up—just reliable impact extraction whenever you need it.

Reloaders who work with multiple calibers appreciate tools like this because they cut downtime and waste. Instead of scrapping a loaded round, you pull it apart, salvage the components, and move on. Pair it with your other Mec reloading accessories to round out your bench setup.

Key Features

• Hand-operated bullet puller—no power tools needed
• Simple impact mechanism: insert cartridge, strike, extract bullet
• Recovers bullets, brass, and other reloadable components
• Made in the USA
• Durable construction for repeated reloading bench use

Frequently Asked Questions

How do I use the Mec 1311095 bullet puller?

Insert your loaded cartridge into the puller with the cap piece that corresponds to your cartridge size, then strike the puller against a hard, flat surface. The force of the blow dislodges the bullet from the case, allowing you to retrieve your components.

What sizes and calibers does it work with?

The puller uses interchangeable cap pieces to fit different cartridge sizes. Ensure you're using the correct cap piece for your caliber for safe and effective operation.

Can I recover my components after pulling a bullet?

Yes. The bullet puller is designed to dislodge the bullet while preserving the case, allowing you to recover most of your reloadable components—bullet, brass, and powder.

Is this tool made in the USA?

Yes. The Mec 1311095 bullet puller is manufactured in the USA by Mec-Gar.