Warne Mountain Tech 1" medium matte scope rings deliver the lightweight precision mount backcountry hunters need when every ounce of gear matters. Built from 7075-T6 aluminum, these rings combine minimal weight with rigidity that won't shift under recoil—critical when your hunt depends on repeatable accuracy after miles of hiking. The matte finish blends seamlessly with most rifle builds while resisting glare in the field.
These rings are machined to tight tolerances and finished with mil-spec hardcoat anodizing that stands up to weather, sweat, and rough handling. Stainless steel hardware resists corrosion in rain, snow, and high-altitude conditions where standard steel fasteners can fail. The design accepts both Picatinny and Weaver rail systems, so they'll mount to virtually any modern rifle platform.
Installation is straightforward: the tactical nut attachments clamp to your rifle's rail at mil-spec 65 in/lb. torque, providing a secure hold that stays put. Sizing to 1 inch fits standard optics tubes, making these a direct swap on rifles running popular hunting scopes. Whether you're glassing from a ridge, making a long stalk, or threading through timber, you'll appreciate the no-nonsense engineering and confidence that comes from gear engineered to perform when conditions get serious.
| Tube Diameter | 1 inch |
| Height | Medium |
| Material | 7075-T6 Aluminum |
| Finish | Matte, Mil-Spec Hardcoat Anodized |
| Hardware | Stainless Steel |
| Rail Compatibility | Picatinny and Weaver |
| Standard | NATO-STANAG |
| Recommended Torque | 65 in/lb. |
These rings accept both Picatinny and Weaver rail systems, making them compatible with the vast majority of modern rifles. The 1 inch tube diameter fits standard hunting scopes. You'll need to verify your rifle's rail type and scope tube size before ordering.
On backcountry hunts where you're carrying your rifle for miles, every ounce adds up. Warne Mountain Tech rings are engineered to eliminate unnecessary mass without compromising strength or precision. The 7075-T6 aluminum provides the rigidity needed to maintain zero while keeping overall rifle weight down.
The tactical nut attachments clamp directly to your rail. Torque them to 65 in/lb. for a secure hold. No special tools or gunsmithing required—a simple torque wrench and the included hardware are all you need for installation.
Yes. The mil-spec hardcoat anodized aluminum resists corrosion, and the stainless steel fasteners won't rust or seize in wet, cold, or high-altitude conditions where standard hardware can fail.
Warne Scope Mounts
Warne Scope Mounts
Warne Scope Mounts
Warne Scope Mounts
