Talley Manufacturing 30Mm High (0.60'') 11Mm Dovetail Rings, Black

Talley Manufacturing 30mm high 11mm dovetail rings deliver a time-tested mounting solution for rifles that use dovetail scope bases. Built to handle the rigorous demands of hunting and range shooting, these rings hold your optic rock-solid without the fuss of modern picatinny systems. If your rifle wears a traditional dovetail base—common on many classic and specialized firearms—Talley's steel construction and precision engineering make them a straightforward choice for reliable scope mounting.

The 0.60" height positions your scope at a standard elevation above the barrel, accounting for standard base-to-bore distance. That measurement matters: too low and you risk recoil issues or obstruction; too high and you're uncomfortable behind the gun. Talley's height gets you in that Goldilocks zone for most rifle setups. The rings are machined from solid steel bar stock rather than stamped or cast, which means better durability and tighter tolerances where it counts.

What separates these from budget alternatives is the attention to fit. Talley's dovetails are cut to the correct angle for a true, repeatable fit in your base—no rocking, no gap-filling shims needed. The Torx clamp screws tighten in a way that distributes pressure evenly around the ring, holding your scope in place through recoil and temperature swings without crushing the tube. Black finish blends with most rifle setups and resists corrosion in field conditions.

These are purpose-built for shooters who want dependable, no-fuss scope retention. Not fancy, not tactical, just rings that work.

Key Features

• Machined steel construction for durability and precision fit
• 30mm ring diameter accommodates standard 30mm scope tubes
• 0.60" height positions scope at standard viewing plane
• 11mm dovetail base compatibility
• Precision-cut dovetails for exact fit and zero movement
• Torx clamp screws for even, secure clamping pressure
• Black finish

Specifications

Frequently Asked Questions

What bases are these rings compatible with?

These Talley rings fit 11mm dovetail scope bases. Make sure your rifle's base matches this standard before ordering; dovetail systems vary, and an 11mm dovetail is specific. If you're unsure, check your rifle's documentation or the base itself.

What size scope tube do these hold?

The rings are machined for 30mm scope tubes, which is the most common size for modern hunting and tactical optics.

Will these rings work with my specific rifle?

These rings require a rifle with an 11mm dovetail base already installed. They do not fit Picatinny rails, weaver bases, or other modern mounting systems. If your rifle has a dovetail base, these will work; if you're unsure what your rifle uses, check with the manufacturer or a gunsmith.

How tight should I clamp the rings?

Torx screws should be snugged firmly to hold the scope securely, but do not overtighten—that risks damaging the scope tube or the rings themselves. Hand-tight with a torx wrench is the general rule; if the scope moves under recoil, tighten in small increments until it's solid.