Redding Titanium Nitride Bushing/.363

The Redding Titanium Nitride Bushing/.363 is a precision neck-sizing bushing built for reloaders who want reduced friction and extended die life during the ammunition assembly process. This .363" bushing features a titanium nitride coating applied over heat-treated steel, a combination that increases surface hardness and makes the sizing stroke smoother and easier on your press. If you're running a Redding neck-sizing die setup and need a replacement bushing or want to fine-tune your neck tension, this is the component that makes the difference in consistent, repeatable cartridge preparation.

Redding's bushing system lets you dial in your neck sizing with precision by swapping bushings in .001" increments. The titanium nitride coating isn't just about reduced wear on your die—it also cuts down on the friction that can drag and mark case necks. Over a long reloading session, that smoother action keeps your press running easier and your cases in better condition, especially if you're processing volume for competition or hunting season.

The .363" size sits in the mid-range of Redding's bushing lineup and is sized to match specific cartridges commonly used in rifle reloading. Make sure you verify your bushing requirement before ordering—Redding offers .001" increments from .185" through .368", so getting the right diameter for your dies and cartridge is essential for proper neck fit and bullet seating.

Key Features

• Titanium nitride coating for reduced sizing friction and extended bushing life
• Heat-treated steel core for durability under repeated use
• .363" diameter sized for specific rifle cartridges
• Precision engineering for consistent neck tension

Specifications

Frequently Asked Questions

What cartridges use a .363" neck-sizing bushing?

The .363" bushing is sized to fit specific cartridges in the mid-range of rifle calibers. Check your cartridge's loaded round diameter or consult Redding's compatibility chart to confirm the correct bushing size for your reloading setup.

How does the titanium nitride coating improve reloading?

The titanium nitride coating increases surface hardness and reduces friction during the sizing stroke. This means easier press operation, less wear on your die, and reduced risk of case-neck marking over extended reloading sessions.

Can I use this bushing in any Redding neck-sizing die?

This bushing is designed to work with Redding's bushing-style neck-sizing dies. Verify that your die is compatible with interchangeable bushings before purchasing.

What's included, and do I need anything else to use it?

You receive the bushing itself. You'll need a compatible Redding neck-sizing die to use it; the bushing alone is a component that installs into the die's bushing cavity.