Redding 73 Style Steel Bushing/.271

The Redding 73 Style Steel Bushing/.271 is a precision neck-sizing bushing engineered for reloaders who demand consistency and reduced die wear. If you're running a Redding Type S press with a bushing-style neck-sizing die, this .271" bushing lets you fine-tune neck tension to match your specific rifle and load, ensuring repeatable cartridge prep from one round to the next.

Built from heat-treated steel and hand-polished to a surface hardness of Rc 60–62, this bushing minimizes the friction and effort required during the sizing stroke—a real advantage when you're processing dozens or hundreds of cases. The hardened sizing diameter resists wear, so your bushing maintains its dimensions and performance across many reloading sessions. Redding offers these bushings in .001" increments throughout the .185" to .368" range, so finding the exact diameter your loads need is straightforward.

The .271" size sits in the middle of Redding's lineup and is a popular choice for common rifle cartridges. Whether you're prepping match ammo for the range, hunting loads, or general shooting, a properly fitted bushing keeps neck runout low and brass life long. If you're already committed to Redding dies and a bushing-style setup, swapping bushings to dial in neck tension is one of the easiest and most effective ways to improve ammunition consistency.

Key Features

• Heat-treated steel construction for durability and long service life
• Hand-polished sizing diameter reduces friction and sizing effort
• Surface hardness Rc 60–62 resists wear across hundreds of reloading cycles
• Fits Redding Type S bushing-style neck-sizing dies
• Available in .001" diameter increments for precise neck-tension tuning

Specifications

Frequently Asked Questions

What press and die setup does this Redding bushing fit?

The Redding 73 Style bushing is designed for Redding Type S bushing-style neck-sizing dies, typically used in single-stage or progressive presses. It does not fit other die manufacturers' bushing systems.

Why would I need a different bushing diameter than .271"?

Bushing diameter directly controls neck tension—how tightly the die squeezes your fired brass. If your loads exhibit loose primer pockets, high runout, or inconsistent velocities, stepping up or down by .001" can dial in the perfect fit for your brass and rifle.

How long will this bushing last?

With a surface hardness of Rc 60–62, the hand-polished sizing diameter resists wear. Most reloaders report years of service before any measurable wear occurs, especially if you're using quality brass and proper sizing lubricant.

Can I use this bushing with other Redding die sizes?

This .271" bushing is a neck-sizing component and works only with Redding Type S bushing-style dies. Different calibers and cartridges may require different bushing diameters—consult your die documentation or Redding's sizing chart to confirm the right fit for your load.