RCBS Full Length Die Set for 28 Nosler Reloading
$92.55
$106.85
(You save
$14.30
)
- Caliber-Gauge:
- 28 Nosler
The RCBS Full Length Die Set for 28 Nosler gives you the two essential dies needed to reload this powerful magnum cartridge from start to finish. If you're running a 28 Nosler and want to stretch case life while maintaining tight, consistent headspace, this set handles the critical sizing and seating operations that define reloading precision. The pair works together to bring your brass to SAAMI minimum dimensions and seat bullets with confidence, shot after shot.
The Full-Length Sizer Die is where it starts. It resizes the case body, decaps spent primers, and opens the neck to accept a fresh bullet—all while holding headspace to minimum tolerances so the case length stays put. The die design includes vents that prevent trapped air and excessive lubricant from damaging your brass during the stroke, a detail that matters when you're running magnum cases through repeated cycles.
The Seater Die completes the job with a built-in roll crimper that secures the bullet as it's seated in one smooth operation. This combination keeps your loads uniform and your rounds ready to chamber without hesitation. For 28 Nosler handloaders who demand consistency and want to maximize brass longevity, this is the foundation die set you need.
Key Features
- Two-die set specifically designed for 28 Nosler bottleneck cases
- Full-Length Sizer Die with integrated expander-decapping unit
- Seater Die with built-in roll crimper for secure bullet seating
- Vented die design prevents air trapping and lubricant buildup
- Headspace held to SAAMI minimum tolerances
Specifications
| Brand | RCBS |
| Caliber | 28 Nosler |
| Die Type | Full Length Sizer and Seater |
| Case Type | Bottleneck |
| Included Components | Full-Length Sizer Die with Expander-Decapping Unit; Seater Die with Bullet Seater Plug and Roll Crimper |
Frequently Asked Questions
What's included in this RCBS 28 Nosler die set?
You get two dies: a Full-Length Sizer Die with an expander-decapping unit, and a Seater Die with a bullet seater plug and integrated roll crimper. These are the two operations you need to go from fired brass to a loaded round.
Will this die set work with my 28 Nosler brass?
Yes, this set is designed for 28 Nosler bottleneck cases and sizes them to SAAMI minimum cartridge dimensions.
Does the seater die crimp the bullet?
Yes. The Seater Die includes a built-in roll crimper that secures the bullet at the same time it's being seated into the case.
What do the vents in the sizer die do?
The vents prevent damage from trapped air and excess lubricant during the sizing stroke, helping protect your brass through repeated reloading cycles.
