RCBS 9426 Standard .30 Cal Bullet Puller Collet - Precision Metal Design

The RCBS 9426 Standard .30 Cal Bullet Puller Collet is a precision metal tool built for reloaders who need to safely pull jacketed bullets from fired brass without damaging either component. If you're setting up a reloading bench and find yourself with loaded ammunition that needs to be taken apart—whether for inventory correction, powder adjustments, or salvaging brass and bullets—a reliable bullet puller is essential. This collet-style puller threads into your single-stage press and gives you the mechanical advantage to extract bullets cleanly and repeatedly.

The .30 caliber sizing means this collet is matched to .30 diameter bullets, so you'll need the right collet for each caliber you reload. The standard 7/8-inch-14 thread pattern fits virtually all modern single-stage presses, making it a straightforward addition to your existing setup. The redesigned precision metal construction is built to handle the job without beating up your brass or deforming bullets you plan to reuse.

Operation is simple: install the collet in your press, insert the loaded cartridge, tighten the collet around the bullet, and work the ram to extract. It's direct, mechanical, and doesn't require any external power or complex setup. For reloaders who pull bullets regularly—whether you're dealing with rejected loads, experimenting with different powders, or just managing your brass inventory—this tool pays for itself fast.

Key Features

• Precision metal collet design for reliable bullet extraction
• Sized specifically for .30 caliber bullets
• Standard 7/8-inch-14 thread pattern fits most single-stage presses
• Redesigned for easier operation and reduced damage to brass and bullets
• Simple mechanical operation with no external power required

Specifications

Frequently Asked Questions

Will this bullet puller work with my press?

The RCBS 9426 features standard 7/8-inch-14 threads, which fit nearly all modern single-stage reloading presses. Verify that your press accepts this thread pattern before ordering.

What calibers can I pull with this collet?

This puller is sized specifically for .30 caliber bullets. If you reload multiple calibers, you'll need a separate collet for each one.

Can I reuse bullets after pulling them?

Yes—the redesigned collet is engineered to extract bullets without damaging them, so you can reuse pulled bullets in future loads if they meet your standards.

Do I need any other tools to use this puller?

You'll need access to a single-stage reloading press with the standard 7/8-inch-14 thread pattern. The puller itself is complete as supplied.