Pearce Grip Extension for Smith & Wesson M&P 9mm Shield Plus - Enhanced Comfort & Control
$6.66
$9.95
Pearce Grip
Pearce Frame Insert M&P Shld Plus
$3.29
$6.00
(You save
$2.71
)
The Pearce Frame Insert for M&P Shield Plus is a purpose-built frame cavity filler designed to seal out dirt and dust while completing the professional look of your Shield Plus frame. If you carry or shoot an M&P Shield Plus and want to protect the frame's bottom rear cavity from environmental contamination—or simply prefer a finished appearance over an open slot—this friction-fit insert solves both problems without modification or permanent alteration to your firearm.
Pearce Grip engineered this insert specifically for Shield Plus frames (which typically ship with 10- and 13-round magazines) to fit snugly in that rear cavity using friction alone. No tools, permanent adhesives, or gunsmithing required. It installs in seconds and can be removed just as easily if you need access to the cavity later. It's a small detail that adds polish to your carry or range gun.
Keep in mind this insert is engineered only for Shield Plus frames. It is not compatible with the original M&P Shield, Shield EZ, Equalizer, or any .45 ACP variants. Verify your model before ordering to ensure proper fit and function.
Key Features
- Friction-fit design—no adhesive or permanent modification needed
- Seals the frame cavity against dust and debris
- Completes the finished look of your Shield Plus frame
- Tool-free installation and removal
Specifications
| Intended Firearm | M&P Shield Plus |
| Fit Type | Friction fit in frame cavity |
| Compatibility | Shield Plus frames only; not compatible with original Shield, EZ, Equalizer, or .45 ACP models |
Frequently Asked Questions
Will this insert fit my M&P Shield or Shield EZ?
No. This insert is designed exclusively for Shield Plus frames and is not compatible with the original M&P Shield, Shield EZ, Equalizer, or any .45 ACP variants.
How is it installed?
The insert uses a friction fit to secure itself in the bottom rear cavity of your Shield Plus frame. No tools, adhesive, or gunsmithing is needed—simply press it into place. It can be removed by hand whenever you need access to the cavity.
What does it do?
The frame insert seals out dust and debris from entering the frame cavity and gives your Shield Plus a finished, complete appearance rather than leaving the cavity exposed.
