The L.E. Wilson Steel Neck Sizer Die Bushing .269 is a hardened stainless steel neck bushing designed for reloaders who demand precise case neck control. Wilson bushings are manufactured in .001" increments, giving you fine-grained options for dialing in consistent neck tension across your brass—a critical factor for accuracy and case longevity. Whether you're tuning loads for competition, long-range hunting, or precision rifle work, this bushing lets you achieve the neck sizing you need without stepping up to the next full size.
The .269 marking on this bushing refers to the middle diameter, which is reamed with a .003" taper. That taper design means you have real flexibility: use the bushing normally for standard sizing, or flip it over (markings facing down) to engage a slightly tighter contact point if your brass has hardened or needs extra fine-tuning. It's an elegant solution when you need less squeeze than dropping to the next smaller bushing would give you, or when vintage or work-hardened brass needs a firmer grip to hold bullets consistently.
Wilson steel bushings are built to specs similar to Redding neck bushings but are not compatible with Forster or RCBS dies, so verify your die system before ordering. If you're upgrading from standard full-length sizing or moving to a neck-sizing rifle, this bushing is a practical step toward the consistency and brass longevity that discriminating handloaders expect.
Key Features
- Hardened stainless steel construction for durability and precision
- Manufactured in .001" increments for exact neck diameter selection
- .003" taper reamed into the middle diameter for controlled sizing
- Reversible design: flip to engage tighter sizing for work-hardened brass or fine-tuning
- Compatible with L.E. Wilson and similar neck-sizing die systems
- Ideal for competition, long-range, and precision reloaders
Specifications
| Brand | L.E. Wilson |
| Product Type | Steel Neck Sizer Die Bushing |
| Size | .269" |
| Material | Hardened Stainless Steel |
| Sizing Increment | .001" |
| Taper | .003" (reamed in middle) |
Frequently Asked Questions
Which dies are compatible with this L.E. Wilson neck bushing?
This bushing is compatible with L.E. Wilson neck-sizing dies and similar systems with comparable specs (such as Redding). It will not work with Forster or RCBS die systems, so confirm your die manufacturer before purchasing.
How do I choose the right bushing size?
L.E. Wilson recommends two methods: (1) Measure the outside neck diameter of your loaded cartridge and subtract .002" to .003" to allow for brass spring-back and proper neck tension, or (2) Measure your case neck wall thickness, multiply by two, add your bullet diameter, then subtract .002" to .003". The .001" increment sizing allows you to dial in precisely.
Can I flip this bushing over for tighter sizing?
Yes. Reversing the bushing so the markings face down engages a slightly tighter sizing point, which is useful for fine-tuning neck tension or working with hardened brass that has sprung back and won't hold bullets with standard sizing. It's a practical option when you need more squeeze than normal but don't want to jump to the next smaller bushing size.
What's the difference between the marked diameter and actual sizing?
The .269 marking refers to the middle of the bushing, which is where the .003" taper is reamed. Since the case neck only reaches the middle during sizing, you get a specific contact point that controls how much the neck squeezes the bullet. This design is what allows the flip-over technique for variable sizing.
