The L.E. Wilson Steel Neck Sizer Die Bushing .268 is a precision reloading component for handloaders who demand tight control over neck tension. This hardened stainless steel bushing fits L.E. Wilson neck-sizing dies and lets you fine-tune how much your case neck grips the bullet—a critical factor for consistent, accurate loads. Whether you're working up competition ammunition or maximizing the lifespan of premium brass, the right bushing diameter makes the difference between mediocre groups and repeatable performance.
Wilson manufactures these bushings in .001" increments, giving you granular control unavailable with larger jumps. The .268 marking indicates the middle diameter of the bushing, which is reamed with a .003" taper. Because case necks only reach the middle section, you can flip the bushing over (markings facing down) to achieve slightly tighter sizing—a useful trick when brass has hardened or when you need to reduce the squeeze on the bullet for specific load development. This reversibility also lets you squeeze out a bit more precision when standard bushing sizes don't quite fit your requirements.
If you're transitioning from Forster or RCBS dies, note that L.E. Wilson bushings are not compatible with those systems—you'll need a Wilson die. For shooters already running Wilson equipment or building a Wilson neck-sizing setup, this bushing integrates seamlessly and offers the repeatability serious reloaders expect.
Key Features
- Hardened stainless steel construction for durability and reliability
- Made in .001" diameter increments for precise neck tension tuning
- .003" taper design allows reversible seating for additional sizing flexibility
- Compatible with L.E. Wilson neck-sizing dies
- Designed to similar specifications as Redding neck bushings
Specifications
| Material | Hardened stainless steel |
| Bushing Diameter Marking | .268" |
| Taper | .003" |
| Increment Size | .001" |
| Compatibility | L.E. Wilson neck-sizing dies only |
Frequently Asked Questions
Will this bushing work with my Forster or RCBS dies?
No. L.E. Wilson bushings are designed specifically for L.E. Wilson neck-sizing dies and are not compatible with Forster or RCBS systems.
How do I select the right bushing diameter for my loads?
Measure the outside neck diameter of your loaded cartridge and subtract .002" to .003" to allow for brass spring-back. Alternatively, measure your case neck wall thickness, multiply by two, add your bullet diameter, and subtract .002" to .003". The resulting number is your target bushing diameter.
Can I use the bushing in two different orientations?
Yes. The bushing can be flipped so the markings face down toward the case, which allows slightly tighter sizing. This reversibility is useful as a fine-tuning tool when brass has hardened or when you need sizing between standard bushing sizes.
What makes these bushings different from the standard ones?
L.E. Wilson offers .001" diameter increments, allowing more precise neck tension control than larger increment systems. The reversibility and tapered design also provide flexibility for load development and brass longevity optimization.
