The L.E. Wilson Steel Neck Sizer Die Bushing .244 is a hardened stainless steel neck sizing component built for reloaders who demand precision and consistency. If you're working up accurate loads in .244 caliber or fine-tuning neck tension on existing dies, this bushing gives you control that generic one-size-fits-all dies simply can't match. L.E. Wilson manufactures these bushings in .001" increments, so you get the exact sizing diameter you need—no approximation, no compromise.
Neck sizing bushings work by creating a consistent bore through which your case neck passes, squeezing the brass to a controlled diameter that holds your bullet with the right amount of tension. Wilson's design features a .003" taper reamed into the bushing, and the marked diameter refers to the middle of that taper—the actual point where your case neck contacts the bushing. This matters for handloaders because it lets you dial in neck tension with real precision. If your brass has work-hardened and is springing back too much, you can flip the bushing upside down (markings facing the case) to achieve a slightly tighter squeeze without stepping down to the next smaller bushing. It's a handy trick for fine-tuning or emergency adjustments when your brass needs extra tension to hold the bullet.
These steel bushings are built to similar specifications as Redding neck bushings, so if you're familiar with that system, you'll recognize the design. One important compatibility note: L.E. Wilson bushings will not work in Forster or RCBS dies, so verify your press setup before ordering. Selection is straightforward—measure your loaded cartridge's neck diameter and subtract .002" to .003" to account for natural brass springback, or calculate based on case wall thickness and bullet diameter using the same offset.
Key Features
- Hardened stainless steel construction for durability and repeatability
- Available in .001" size increments for precise neck tension control
- .003" taper design allows reversible bushing orientation for fine-tuning squeeze
- Designed to similar specifications as Redding neck bushings
- Ideal for handloaders seeking consistency across multiple reloading sessions
Specifications
| Caliber/Size | .244 |
| Material | Hardened stainless steel |
| Taper | .003" |
| Size Increment | .001" |
| Compatibility | L.E. Wilson and Redding die systems only; not compatible with Forster or RCBS dies |
Frequently Asked Questions
Will this L.E. Wilson bushing work in my Forster or RCBS press?
No. L.E. Wilson neck bushings are not compatible with Forster or RCBS die systems. They are designed for use in L.E. Wilson and Redding reloading presses.
How do I choose the correct bushing size for .244?
Measure the outside diameter of a loaded round and subtract .002" to .003" to allow for brass springback and correct neck tension. Alternatively, measure your case neck wall thickness, multiply by two, add your bullet diameter, then subtract .002" to .003". Since L.E. Wilson makes bushings in .001" increments, you can dial in exactly what you need.
What does it mean to flip the bushing upside down, and when would I do that?
The marked diameter on the bushing refers to its middle, where the .003" taper reaches its smallest point. Normally, you insert the bushing markings-up. If your brass has work-hardened and is springing back too much to hold the bullet, you can reverse the bushing (markings facing down toward the case) to achieve slightly tighter sizing without moving to the next smaller bushing. This is useful for fine-tuning or emergency adjustments.
What's included with this bushing?
You receive the L.E. Wilson Steel Neck Sizer Die Bushing .244. It is a component designed to work with an existing L.E. Wilson or Redding neck sizing die system; it is not a complete die.
