Hornady Match Grade Bushing .309"

The Hornady Match Grade Bushing .309" is a precision neck sizing bushing designed for reloaders who demand tight, consistent case neck tension. This interchangeable bushing works with Hornady's Match Grade die system to let you dial in the exact neck fit you want for your cartridge—eliminating the guesswork and over-working of brass that comes with standard sizing dies. Available in .002-inch increments across the product line, these bushings are the key to building ammunition that chambers reliably and shoots groups that matter.

If you're running Match Grade dies, swapping bushings takes seconds and transforms your setup for different loads, bullet weights, or brass conditions. The self-centering design keeps everything concentric, and the engineering behind these bushings reflects Hornady's commitment to match-grade quality—the kind of precision that pays off downrange, whether you're a competitive shooter, precision hunter, or serious handloader chasing tighter tolerances than factory ammunition can offer.

The .309" bushing is one size in a lineup available in .002-inch steps, so you can find the exact fit for your brass and bullets. Pair it with either a Match Grade full-length die (for complete case sizing) or a Match Grade neck die (for neck sizing only with shoulder bump), and you've got a reloading system built for consistency and case longevity.

Frequently Asked Questions

What does a .309" bushing mean, and which cartridge should I use it with?

The bushing diameter (.309") controls how snugly the case neck is sized around your bullet. The specific cartridge match depends on your bullet diameter and desired neck tension; refer to your load data and Hornady's bushing selection guide to confirm the right size for your caliber and component combination.

Can I use this bushing with other reloading die brands?

This bushing is designed for Hornady Match Grade dies. Compatibility with other brands' dies is not confirmed in the product specifications, so we recommend checking Hornady's documentation or contacting them directly before mixing brands.

How do I know what bushing size I need?

Hornady bushings are available in .002-inch increments to match different bullet diameters and desired neck tensions. Your load manual and the specific bullet you're using will guide you; most reloaders start with a bushing 1–2 thousandths smaller than their loaded round diameter to achieve proper bullet tension without excessive case-neck pressure.

Is this bushing included with Match Grade dies, or do I buy it separately?

This bushing is sold separately from the dies themselves. The dies come with a bushing, but many reloaders buy additional bushings to quickly switch between different bullet sizes or loads without swapping out the entire die.