Hornady 095333 Bullet Feeder Die for .44 S&W Special and .44 Magnum

If you're running a progressive press setup for .44 S&W Special or .44 Magnum handloads, the Hornady 095333 Bullet Feeder Die is built to streamline your workflow and keep rounds moving consistently. This die integrates with Hornady's Lock-N-Load Bullet Feeder system to automate bullet seating—a serious time-saver when you're processing volume on pistol rounds. The tube and collet design grips each bullet firmly until a fresh case pushes into the collet, then releases it smoothly into the seating position. It's the kind of steady, repeatable motion that lets you focus on quality rather than fiddling with individual bullets.

Built from solid steel, this die is threaded to the industry-standard 7/8"-14 spec, so it seats directly into any compatible progressive press station. No exotic tools or fussy setup required—it's made to bolt in and work. Whether you're feeding magnum loads for hunting or running high-volume practice ammunition for competition or the range, the feeder die eliminates the tedious manual bullet placement that bogs down hand-loading sessions.

Keep in mind that the die itself is one piece of the system: you'll need the separate Lock-N-Load Bullet Feeder assembly and the appropriate Bullet Tubes (sold independently) to complete the setup. But once you have them running together, you'll understand why serious reloaders reach for this solution when they're ready to speed up their press time.

Key Features

• Tube and collet design holds bullets securely and releases smoothly on case contact
• Solid steel construction for durability and consistent performance
• Industry-standard 7/8"-14 threading—fits any compatible progressive press station
• Designed for .44 S&W Special and .44 Magnum
• Integrates with Hornady Lock-N-Load Bullet Feeder system
• No special tools needed for installation or operation

Specifications

Frequently Asked Questions

Does this die work with any progressive press?

The die itself uses the standard 7/8"-14 threading and will fit any press station with that spec. However, the Lock-N-Load Bullet Feeder system itself must be compatible with your press model. Check your press documentation or with Hornady to confirm compatibility before purchasing.

What do I need to buy separately?

The die is just one component. You'll need the Hornady Lock-N-Load Bullet Feeder assembly and the appropriate Bullet Tubes for your caliber, both sold separately.

Can I use this for both .44 S&W Special and .44 Magnum?

Yes. This single die is designed to handle both .44 S&W Special and .44 Magnum cartridges.

Do I need special tools to install it?

No. The die threads directly into a standard 7/8"-14 press station with no special tools required.