Hogue Rubber Grip Panels S&W Full Size 9mm Luger, 40 S&W Black

Hogue rubber grip panels for Smith & Wesson full-size 9mm and .40 S&W pistols deliver the comfort and control you need for reliable shooting. Whether you're at the range, in the field, or carrying for personal defense, these two-piece grip panels replace your factory single-piece grip with durable rubber construction that absorbs recoil and provides a secure, non-slip purchase even with a light glove or wet hands. The straight backstrap design is engineered to fit the ergonomics of S&W full-size frames without adding bulk.

Installation is straightforward: these grips use a mainspring retainer system that screws into threaded bosses, secured by the existing pin that holds your stock grip. The hardware you need comes included with the panels, so you can swap them out in minutes without gunsmithing. It's a no-fuss upgrade that transforms how your gun feels in your hand.

Hogue has been making grips for serious shooters since the 1980s, and their rubber compounds are proven to withstand years of hard use. The black finish matches most S&W full-size carry and range guns. Note that these panels are designed for non-decocker models—they will not fit frame decocker variants with a 2 or 7 in the third digit of the model number (such as the 5676 or 4026).

Key Features

• Two-piece rubber construction replaces single-piece factory grip
• Straight backstrap design fits S&W full-size ergonomics
• Non-slip rubber surface for secure purchase in all conditions
• Absorbs recoil and reduces felt impact
• Mainspring retainer system with included hardware for easy installation
• Durable black finish

Specifications

Frequently Asked Questions

What S&W full-size models do these grips fit?

These Hogue panels are designed for S&W full-size models including 5903, 5904, 5906, 5944, 5946, 5943, 4006, 4046, 4096, 410, 411, 910, and 915. They will not fit decocker models with a 2 or 7 in the third digit of the model number, such as the 5676 or 4026.

What comes in the box?

The grip panels come with the mainspring retainer and screws needed for installation. You do not need to purchase additional hardware.

How do I install these grips?

The panels install using the included mainspring retainer, which is pinned into position using the same pin that holds your stock grip. The mainspring retainer provides the threaded bosses where the grip panels screw on. Installation takes just a few minutes and requires no special tools.

Are these grips for 9mm and .40 S&W?

Yes, these Hogue panels are made for full-size S&W frames chambered in both 9mm and .40 S&W.