Hogue 60007 OverMolded Monogrip Cobblestone Pink Rubber with Finger Grooves for S&W J Frame with Round Butt

The Hogue 60007 OverMolded Monogrip is a single-piece grip designed specifically for Smith & Wesson J-frame revolvers with round butts. If you shoot a J-frame and find the stock grip leaves you fighting recoil or struggling with a consistent hold, this grip addresses both problems without any permanent modifications to your revolver. The Monogrip uses a patented steel stirrup that clips over your existing pin or bottom strap—no gunsmithing, no drilling, just slide it on and shoot.

The real advantage here is the high handhold on the backstrap. By raising your grip position relative to the bore axis, you naturally lower muzzle rise during recoil. That matters if you're running double-action strings at speed or practicing rapid-fire recovery. The ambidextrous palm swells work equally well for right- and left-handed shooters, so your shooting buddy can borrow your gun without fumbling for the "other" grip. Finger grooves guide your hand into a consistent hold every time you draw or present.

The cobblestone texture and pink rubber construction deliver genuine grip security even when your hands are wet or sweaty. This isn't a dress-up grip—it's a working accessory for shooters who want to run their J-frame hard. Whether you're training at the range or carrying for defensive work, the Monogrip gives you better control and faster sight recovery without requiring a visit to the gunsmith.

Key Features

• Single-piece OverMolded rubber construction—no assembly required
• Patented steel stirrup system installs without modifications to the firearm
• High-hold backstrap design reduces muzzle rise and aids recoil recovery
• Ambidextrous palm swells suit right- and left-handed shooters equally
• Finger grooves promote consistent hand placement
• Cobblestone texture provides secure purchase in all conditions

Specifications

Frequently Asked Questions

Will this grip fit my Smith & Wesson J-frame revolver?

This grip is designed for S&W J-frame revolvers with round butts. Verify your revolver's frame type and butt configuration before ordering to ensure compatibility.

Do I need to have my gun worked on at a gunsmith to install this?

No. The Monogrip uses a patented steel stirrup that clips over your existing pin or bottom strap. Installation requires no gunsmithing or permanent modifications to your firearm.

Can left-handed shooters use this grip?

Yes. The grip features ambidextrous palm swells designed to provide equal comfort and control for both right- and left-handed shooters.

What does the high-hold backstrap design do?

The elevated grip position lowers the bore line relative to your hand, which reduces muzzle rise during recoil and helps you recover faster between shots—especially useful for rapid-fire training or defensive practice.