Frankford Arsenal X-10 Progressive Press Tool Head - Precision Reloading Accessory

The Frankford Arsenal X-10 Progressive Press Tool Head is a replacement accessory designed for reloaders who want to switch between calibers and ammunition types without the downtime and frustration of a complete press teardown. If you run a Frankford Arsenal FX-10 Progressive Press and load multiple calibers—or share press time with another shooter—this tool head swap system cuts setup time dramatically. Rather than breaking down dies and reconfiguring your entire press station, you simply swap tool heads, keeping your dies and powder measure already tuned for each caliber. It's a practical efficiency gain for serious handloaders who value consistency and time at the bench.

Built to the same precision standards as the FX-10, this tool head features a 10-station configuration and accepts standard 7/8×14" reloading dies. The modular design means you can have multiple tool heads set up with different die combinations—one for .45 ACP, another for 9mm, a third for .38 Special—and swap them in seconds. That approach eliminates the small adjustments and creep that can happen when you repeatedly dial in the same press, keeping your ammunition consistent shot to shot.

This is smart equipment for high-volume reloaders, competition shooters who load for multiple cartridges, or anyone who shares a press and wants to minimize setup friction. The tool head is an investment in your reloading routine—one that pays dividends every time you load.

Key Features

• 10-station progressive press configuration
• Accepts standard 7/8×14" dies
• Quick swap design minimizes changeover time between calibers
• Allows pre-configured tool head setups for different cartridges
• Compatible with Frankford Arsenal FX-10 Progressive Press

Specifications

Frequently Asked Questions

Will this tool head fit my Frankford Arsenal FX-10 Progressive Press?

Yes, this X-10 Progressive Press Tool Head is designed as a direct replacement for the FX-10 and will swap in and out of that press.

Can I use my existing dies with this tool head?

This tool head accepts standard 7/8×14" dies, the industry-common thread size. If your existing dies use that thread standard, they will work with this tool head.

How does swapping tool heads save time when I reload?

Rather than removing and reinstalling dies each time you switch calibers, you prepare multiple tool heads in advance—each pre-configured with a different caliber's dies and powder measure settings. You simply remove one tool head and insert another, keeping all your die adjustments and powder settings intact for each load recipe.

What comes with this tool head?

This is a replacement tool head accessory for the FX-10 press. Based on the product information provided, it includes the 10-station tool head; verify compatibility with your specific press model and die setup before purchase.