Egw Walther Ppq Trijicon Rmr Sight Mount

The EGW Walther PPQ Trijicon RMR sight mount gives you a clean, reliable way to run a modern red dot on one of the most popular duty and sport pistols out there. Built from 7075 aluminum with a matte black hardcoat finish, this mount sits low and solid on your PPQ's dovetail, letting you mount a Trijicon RMR or Holosun HS507C without any gunsmithing. If you shoot a Walther PPQ in any of its classic or M2 configurations—including the PPQ 45, PPQ 45 SD, or PPQ Sub Compact—this mount slides in where your rear sight was, and comes back off just as easily if you ever need to return to iron sights.

Installation is straightforward: remove your factory rear sight, install the EGW mount in the dovetail, and you're ready to mount your optic. The kit includes everything you need—two 8-32 button head screws and an 8-32 set screw—along with the knowledge that blue Loctite and a 5/64" allen wrench are all the tools you'll need beyond that. No permanent modifications, no headaches. Torque the screws to 15 foot-pounds and you're done.

If you run a Walther PPX, Creed, Creed 10 Round, PPS, or PPS M2, this mount fits those too. Just note it won't work with the PPQ 22, PPQ Q4 Tac, or Q5 Match—confirm your model before ordering. The matte black finish blends seamlessly with modern pistol aesthetics and won't catch light downrange.

Key Features

• 7075 aluminum construction with matte black hardcoat finish for durability and corrosion resistance
• Direct dovetail fit—no slide milling required
• Compatible with Trijicon RMR and Holosun HS507C red dot sights
• Fully reversible: swap back to iron sights anytime
• Includes all mounting hardware (button head screws and set screw with 5/64" hex key)
• Compact profile: 1.78" length × 1.1" width

Specifications

Frequently Asked Questions

Which Walther PPQ models does this mount fit?

This mount is designed for the Walther PPQ Classic (M1), PPQ M2 (all models), PPQ 45, PPQ 45 SD, and PPQ Sub Compact. It also fits the P99 (all models), PPX (all models), Creed, Creed 10 Round, PPS (all models), and PPS M2 (all models). It does not fit the PPQ 22, PPQ Q4 Tac, or Q5 Match.

Will I need to have my slide milled to use this mount?

No. This mount installs directly into your Walther's existing dovetail in place of the factory rear sight. No permanent modifications or slide milling required.

What red dots work with this mount?

The EGW mount is designed to accept Trijicon RMR and Holosun HS507C red dot sights.

What hardware is included, and what tools do I need?

The mount comes with two 8-32 button head screws and one 8-32 set screw. You'll need a 5/64" allen wrench to install them. The instructions recommend using blue Loctite on the mounting screws and torquing them to 15 foot-pounds.