Egw S&W K,L,N Frame Scope Mount Silver

The EGW S&W K, L, N Frame scope mount is a one-piece Picatinny rail that brings optics-ready capability to classic Smith & Wesson revolvers without permanent modification. Built from 6061 T6 aluminum and precision machined to MIL-STD 1913 specifications, this mount bolts directly to the factory scope mount holes on your revolver's receiver — no drilling, no tapping. It's the fastest way to add a rifle scope, red dot, or low-power optic to a K-, L-, or N-frame revolver for hunting, match shooting, or extended-range practice.

The full-width Picatinny rails let you dial in eye relief exactly where you need it and swap between Picatinny or Weaver rings without fumbling. The aluminum construction keeps things light, and the milled center channel reduces weight even further for tactical setups. EGW machines every unit to ±.002" tolerances, so you get repeatable, rock-solid performance out of the box.

Installation is straightforward: the mount uses socket head Torx screws (included, along with the wrench) and EGW specs 20 inch-lbs of torque plus a drop of blue Loctite for a permanent hold. Whether you're setting up a hunting revolver or tuning a competition gun, this mount gives you the flexibility of modern optics on a proven platform.

Key Features

• One-piece Picatinny rail mounts directly to factory scope holes — no drilling or tapping required
• Accepts both Picatinny and Weaver scope rings for maximum flexibility
• Precision machined from 6061 T6 aluminum to MIL-STD 1913 ±.002" tolerances
• Milled center channel design reduces weight for tactical applications
• Includes socket head Torx screws and hex wrench for installation
• Silver anodized finish

Specifications

Frequently Asked Questions

Will this mount fit my Smith & Wesson revolver?

This mount is engineered for S&W K-frame, L-frame, and N-frame revolvers and attaches directly to the existing factory scope mount holes on the receiver. Check your revolver's frame size to confirm compatibility.

Can I use both Picatinny and Weaver rings with this mount?

Yes. The Picatinny rail accepts both Picatinny and Weaver scope rings, giving you flexibility in optic choice and ring selection.

Do I need to drill or tap my revolver to install this?

No. The mount is designed to bolt directly to the factory scope mount holes — no gunsmithing required.

What torque specification should I use during installation?

EGW recommends 20 inch-lbs of torque on the socket head Torx screws. Apply a small amount of blue Loctite to the fasteners for a permanent hold.