Egw Optic Ready Adapter Plate For Trijicon Rmr Fits Sig M17 Blk

The EGW Optic Ready Adapter Plate for Trijicon RMR lets you mount a Trijicon RMR red dot directly to your Sig M17 by replacing the factory rear sight. It's a simple, reversible solution: remove your dovetail-mounted rear sight, install the EGW plate in its place, and you've got a clean, co-witnessed platform for your RMR. Need your iron sights back? Swap them out whenever you want. The plate ships with mounting hardware and a pair of flat-head cap screws sized for the RMR's footprint.

This is purpose-built for shooters who want a red dot on their M17 without permanent modifications. The dovetail interface means no gunsmithing required, and the reversibility makes it ideal if you rotate optics between guns or need to return to irons for training or duty use. Installation is straightforward: remove the rear sight, seat the EGW mount in the dovetail, and secure your RMR with the included screws and blue Loctite.

Important: this adapter is engineered specifically for the Sig M17 platform and the Trijicon RMR footprint. It does not fit the P320 RX or P320 X-Five with Romeo1 cut, and it is not compatible with military surplus M17 variants. Verify your exact frame and optic before ordering to ensure proper fit.

Key Features

• Direct Trijicon RMR mounting on Sig M17 via dovetail replacement
• Fully reversible—remove and reinstall your rear sight at any time
• No permanent modifications or gunsmithing required
• Mounting hardware and RMR screws included
• Clean, low-profile design that preserves sight picture and handling

Specifications

Frequently Asked Questions

Will this fit my Sig P320 or military M17 surplus gun?

No. The EGW adapter is designed specifically for the civilian Sig M17 dovetail. It is not compatible with the Sig P320 RX, P320 X-Five with Romeo1 cut, or military surplus M17 variants. Verify your exact frame and sight cut before purchasing.

Can I take the adapter off and put my rear sight back on?

Yes. The adapter mounts in the same dovetail as your factory rear sight, so you can remove it and reinstall your iron sights at any time. No permanent modifications are made to the gun.

What comes in the box?

The mount ships with two flat-head cap screws (sized for Trijicon RMR attachment) and mounting hardware for installation. You'll need a 5/64" allen wrench to install the RMR onto the plate. Installation instructions are included.

What torque spec should I use for the RMR mounting screws?

Apply blue Loctite to the provided screws and torque them to 15 in/lbs. A small piece of paper placed between the red dot and the mount during installation can make future removal easier and prevent Loctite contamination of the optic.