Crimson Trace LS250 LaserSaddle 5mW Red Laser (633nm) - Black Finish for Mossberg 500, 590, Shockwave

The Crimson Trace LS250 LaserSaddle is a red laser sight purpose-built for Mossberg 500, 590, and 590 Shockwave shotguns in 12 and 20 gauge. If you run a Mossberg pump shotgun and want fast, intuitive target acquisition—whether you're hunting upland game, running clay courses, or training for defensive scenarios—this laser sight mounts directly to the receiver saddle with a clean, rugged profile. The 5mW red laser (633nm wavelength) gives you an instantly visible aiming point in indoor and low-light conditions, without eating into your sight picture or requiring you to shoulder the gun differently.

The LS250 uses multiple ambidextrous pressure-activation pads, so you can paint targets from either hand or during awkward gun handling. A dedicated Master On/Off switch lets you kill power completely when the gun goes back in the safe—no accidental drain, no guesswork. Windage and elevation are user-adjustable, so you can dial it in to your point of impact in minutes. The laser ships pre-sighted at 50 feet and comes with two CR2032 batteries; expect about 3 hours of runtime before you need to swap them. Installation is user-handled—no gunsmith required—but your receiver must be drilled and tapped (check your specific Mossberg model to confirm). The black polymer body is tough and lightweight, and Crimson Trace backs it with a three-year full warranty.

One note: the LS250 fits 12 and 20 gauge receivers only; it will not work with .410 bore shotguns.

Key Features

• 5mW red laser (633nm) for fast target acquisition in low light
• Multiple ambidextrous pressure-activation pads for either-hand operation
• Master On/Off switch for complete power control
• User-adjustable windage and elevation
• Factory sighted at 50 feet; no gunsmith install needed
• Lightweight polymer construction in matte black
• Approximately 0.50-inch dot size at 50 feet
• Three-year full warranty

Specifications

Frequently Asked Questions

Will this LS250 laser fit my Mossberg shotgun?

The LS250 LaserSaddle fits Mossberg 500, 590, and 590 Shockwave shotguns in 12 gauge and 20 gauge only. Your receiver must be drilled and tapped to accept the mount. It does not fit .410 bore models. Check your owner's manual or contact Mossberg to confirm your gun has a receiver drilled and tapped for this accessory.

What's included in the box?

The LS250 comes with the laser sight itself, two CR2032 batteries, and everything you need for user installation. No gunsmith trip required.

How long does the battery last?

You'll get approximately 3 hours of runtime from the two included CR2032 batteries. The Master On/Off switch lets you shut it down completely between uses to preserve battery life.

Can I adjust the laser if it shoots off target?

Yes. The LS250 is user-adjustable for both windage and elevation, and it ships pre-sighted at 50 feet. You can dial it in to your gun's point of impact without any tools or professional help.